▲ 1 r/SolidWorks
Parametric comb design help
Hello,
I need help with my drawing. I want to create parametric "comb" design, where you set the number of teeth you want to have. Total length of the comb (basically bottom line in picture) is calculated based on that number. Now i can't figure out how to connect two points (the ones on the end of lines in picture) that end up in the same place after calculation to create closed sketch to later extrude it (points separated in picture). Also lets say that I can't do it with feature pattern, I want it in sketch with sketch pattern.
u/Equivalent-Interest8 — 9 days ago