r/intexpools

Intex 15ft pool issue:

Thought we leveled the ground, but now that it’s ~half full we’re seeing about a 5” difference in water.

Water levels:

• High side: 25” left to fill

• Low side: 20–21” left to fill

• Slope spans ~4 frame sections and is consistent (not a dip). About 1/3 of the pool shares the deeper end.

Everything I read says that’s too much of a difference but I am curious since the deeper end takes up so much of the pool might it have less chance of busting or does this require draining and resetting before we go further?

We are currently filling up an intex 32x14 pool the sides are bowing inward which I know is normal , however one of the corner joints looks like it’s about to pop out . What do we do to fix it ? Is this normal ? Should I stop filling up the pool or do I keep filling it up? Is this caused by the bowing side walls? Will the corner joint correct itself after the pool fills up more or will it pop out and collapse the side of the pool? Someone please help if you have experienced this before. Thank you