Jetson Orin Nano Dev Kit SD card bootup issue
Hello everyone,
I bought jetson nano dev kit about 3 weeks ago with a lot of interest in starting with some projects. But, so far, I have had no success in setting it up. I am a beginner with these boards. Previously, I have only used Rpi 4 and 3 which seemed to be extremely easy to setup.
I have the following accessories:
- 19V/2.37A and a 19V/6A Power adapter
- 512GB NVMe SSD Gen3 M.2
- 64GB SD card
- DP to DP cable and monitor
- Windows 10 PC
- Jetson has > 36.4 UEFI firmware version
I am following the intructions to install JetPack 6.2.1. I am at the section “Boot with JetPack 6.x SD Card” step 4. (link to instructions - here) Note: I do not have a Ubuntu OS on any of my other PCs.
After flashing the image to SD card, I power-on the jetson board and see the following screen:
Initially, after this screen, it would start logging a lot of lines on black screen starting with numbers or OK in square brackets.
While trying the same thing today, after this screen, the fan stops for a few seconds and then starts again. But, the screen is completely black now. I do not understand how to solve this issue.
I need help to solve this as soon as possible.
I tried to SSH via USB and Ethernet but no success. I think, during boot, it is not even able to reach the network setup stage.