u/AlanRosenthal

▲ 1 r/askaplumber

How would I mount/connect this

I wanted to mount this to the outside of my house: Glass Filler Faucet Wall Mount

I was wanted to connect it to a water filter. something like this guy

The house is 2x4 exterior walls with cedar shingle siding. The water line I want to connect it to is 1/2" copper.

What's the best way to mount it to the outside of the house and connect it to water inside?

https://preview.redd.it/hv5ksgze8s2h1.png?width=2462&format=png&auto=webp&s=22ca37b9c64c3f1b33ee788519762031b97a7ef9

https://preview.redd.it/uki4ityg8s2h1.png?width=1396&format=png&auto=webp&s=bc63a2ef254a17854d07443d6946e9b7dc183920

https://preview.redd.it/otabvu0j8s2h1.png?width=1396&format=png&auto=webp&s=0b0a465f3be49ef4ccf1703d783d8d934d4d2f14

https://preview.redd.it/3ognym6l8s2h1.png?width=2462&format=png&auto=webp&s=d6adc6cf7ebac0acb1e3d2a46930781406006562

reddit.com

u/AlanRosenthal — 23 hours ago

▲ 0 r/PCB

I'm designing a dev board to test out NeoPixel (both SK6805-EC15 and SK6805-EC20). The goal is to power it off a 3V battery (CR2032) and have the MCU be a low ram chip (STM32C0).

The SK6805 need 5V so I have both a boost power supply (TPS610997YFFR) and level shifter (SN74LVC1T45DBVR).

I'm guessing the battery might be insufficient so I have a jumper to disconnect the battery if needed.

I'm going to have the boards made at JLCPCB

Any suggestions? Thanks in advance

u/AlanRosenthal — 26 days ago