God damn wood pla
So I’ve been experimenting with wood pla and clear PETG within the same print using a quick no cool-down pause and I hit a breaking point unfortunately. I had totally clogged the extruder, and I was no longer able to unload or load any filament.
Eventually heating up the nozzle enough melted the wood pla line enough to start pulling out the filement.
Until I hit a hard part at the very end of the feeding tube (the entrance). The tip of the filament must of made a burnt glob of wood pla and is now stuck in my tubing. It’s only 2 inches long.
Help getting it out :( the pic shows the small end that broke off, and there’s about the same size end inside, but with a melted glob I assume, making it impossible to pull out the diameter of the entrance. It slides easily inside the tube though, just doesn’t pass through the feeder entrance.