u/Careful-Living-4014

[https://github.com/Engineer-By-Mistake/test\\\_lfr\](https://github.com/Engineer-By-Mistake/test\_lfr)

this is the code that I flashed.

I flashed it through duf mode and st programmer. and my stm32 board only pa15,pb15 and pb4 is at high and they are not even initialized

[https://github.com/Engineer-By-Mistake/test\\\_lfr\](https://github.com/Engineer-By-Mistake/test\_lfr)

this is the code that I flashed.

I flashed it through duf mode and st programmer. and my stm32 board only pa15,pb15 and pb4 is at high and they are not even initialized

[https://github.com/Engineer-By-Mistake/test\\\_lfr\](https://github.com/Engineer-By-Mistake/test\_lfr)

this is the code that I flashed.

I flashed it through duf mode and st programmer. and my stm32 board only pa15,pb15 and pb4 is at high and they are not even initialized

[https://github.com/Engineer-By-Mistake/test\\\_lfr\](https://github.com/Engineer-By-Mistake/test\_lfr)

this is the code that I flashed.

I flashed it through duf mode and st programmer. and my stm32 board only pa15,pb15 and pb4 is at high and they are not even initialized

https://github.com/Engineer-By-Mistake/test_lfr

this is the code that I flashed.

I flashed it through duf mode and st programmer. and my stm32 board only pa15,pb15 and pb4 is at high and they are not even initialized

hey so i have stm32f411ceu6 and have configured pin pa 13 and pa 12 as gpio pin and now I am able to flash the chip but it is not executing any code can you guys help and the hardware side it fine as it ran my previous code