Separating SRBs Part 2
The original design’s gas release hole was too small and the engine was ejected out the back, however the booster did separate. So I made the hole bigger but it was too big so I went throught a couple design iterations and got one to work. So I flipped it vertical but it wasn’t working and I think that was for a few reasons: one the motors was a B4 not a C6 which messed with it a little bit. But the main reason was the hole was just a little too small and the tolerance on the motor mount was too fine for a 3d printer and the engine would just fire out the back. So I flipped the whole thing back horizontal and glued the engine in place and now it works. So tomorrow I will go vertical again to test it out. And if the works as intended then I will strap two of them to a rocket and go fly it in June!