My drawers have rounded corners but also where the base of the draw meets the wall it curves upwards rather than just going directly vertical. Is there a gridfinity generator that will let me specify the radius of both the corners and the vertical fillet?
My print starts off fine but then after a while it stops extruding. I've checked the nozzle isn't blocked and replaced the ptfe tubing in case it was catching. Now I'm out of ideas?? Please help!
Printer: QIDI Q2
Material: PLA-CF
Bed temp 60c
Nozzle 220c
I'm trying to print a large tray that is virtually the entire width of the pad (269.5mm). While it's printing the base of the tray the cable chain is drooping which is causing it to hit against the side of the case and it doesn't sound very healthy. Is there something I can do to fix this?
https://i.redd.it/9g9cwp8j2syg1.gif
My printer is working great but I'm curious as to what this flashing red light is in the toolhead?
