Advice for print quality
Hello, I just bouger my first printer after lurking for a while.
I made my first test print and I’m looking for feedback on print quality and possible way to improve it.
As you can see, there is a big visible seem on the left side and I do not know if this is to be expected or not.
Also the arches (sides of the cabin) are not very clean.
I used Elegoo rapid pla + with the following settings:
0.4mm nozzle
Nozzle temp 215 C
Bed temp 60 C
O.16mm layers height
Max volumetric flow rate 32mm^3/s
Outer wall speed 50mm/s
Seem position: back
Also I’m thinking of getting a 0.2mm nozzle for high details print. Any feedback on that? And I was also wondering if the 0.6mm is of any interest at all?
My short term goal is to be able to print the main test prints properly before diving into my projects.