I am about to give up with this printer. It is a constantly headache to he honest.
As a last resort I need means to wire the BLTouch to the main board as it is constantly failing when connected to the pass-through board.
However, I don't see where should I connect it.
Searching online Insee multiple ways, but I don't have space?
Hello, everyone,
I recently replaced the stock hotend for an all-metal hotend and I intend to follow Ellis Calibration guide as a first set-up after multiple issues with the printer.
However, on step one: Extruder Calibration, the guide mentions to disconnect the bowden tube and extrude 100mm of filament.
I tried doing this cold as the guide suggests, but given the long distance that separates the extruder to the hotend it seems it lacks the force to push the filament. Same thing applies to extruding hot.
Any solutions to this impasse?
I really, really need this thing calibrated.