Upgrading Case Fans for Majesty Falcon Case
I would like to share with my expreince to upgrade fans ans replace thermal past for GPU
Noctua NT-H2
I have a Majesty Falcon case that came with 8 fans:
3 side fans
3 bottom fans
2 rear fans
360mm AIO support on the top hydroshift 360R (damage fans replace by Arctic P12 Pro)
I searched for the best budget-friendly fans and found Arctic P12 Pro and Arctic P12 Reverse fans.
I also added an extra Arctic fan hub because each Arctic P12 Reverse fan draws 0.04A, and I preferred not to connect all of them directly to a CHA_FAN header since the maximum supported current is 1A.
I use Fan Control software. Also, the three bottom intake fans are connected to the W_PUMP+ header so they can be controlled separately.
My hardware:
GPU: Asus TUF Gaming RTX 3080 Ti OC 12GB
CPU: AMD Ryzen 7 7700X (AI Overclocking enabled)
I created custom curves in Fan Control with a maximum fan speed limit of 2400 RPM.
I also adjusted the GPU fan curve and used mixed sensors for some fan curves instead of relying only on CPU temperature.
Current results while playing Battlefield 6, with a room temperature of 23°C:
GPU: 57°C
CPU: 60°C
These temperatures are the current results of my setup.
Also I changed thermal paste for the GPU as picture attached almost gone 🥹