u/Feeling-Chicken3664

Hope it’s the right place to ask for help..

I had this x200s perfectly fine until i decided to libreboot it. I opened it up and read some docs so the spi chip was actually wson8 and i had bought a soic8 clipper, so i bought a compatible and libreboot approved soic8 8mb chip, i flashed the libreboot binary into it successfully with a raspberry pi pico on the other side of the pico, i confirmed it was installed right, so i soldered it to the board back (cleanly installed with hot air station and some pre-applied flux) And i assembled it back, but upon powering it up, there is no POST, no noise or heat at all! Anyone experienced something similar? And what could be the issue