If you ever wanted a piece of your favorite rally car on your wall, now’s your chance!
Printed at 40% scale (trust me I would’ve made it at full scale if I could).
More color/livery options below!
Hey gang, the diy 3d printed poker chip from MSA just got a small update!
The side of the chip got gold accent lines to match the artwork a little better. And to make it easier to print a shitload of these, an extra print plate was added with as many chips as I could fit on it (13)
My bad guys this one isn’t done yet
Makerworld in the comments
I got some pet vinyl for stickers from bambulabs and for the life of me my portrait 3 can’t cut it. You’ll see where it cuts but when I try to remove the cut pieces, I usually can’t get it off. I tried some vinyl settings and even just turned up the force, added more passes, and slowed it down but nothing. Am I doing something wrong? Pretty new to this