Okay, I have A LOT of details, so you truly understand my situation.
I've had two rolls of Fujifilm 120 rolls unwind while in the camera. Here are the situations.
- FujiGSW690III ----> I had a roll of 400h (2 years expired at the time and frozen before use). I shot the entire roll and then advanced multiple times till I knew the roll was wound on the right side of the camera. Well, I left the roll in there till the end of the night (I was at a wedding), so around 4 hours. When I opened the back of the camera and took out the roll, it was EXTREMELY LOOSE. So much so that when I looked at the top and bottom of the roll, the film & backing were visible on about 50% of the roll. I assumed it could not be salvaged and scrapped it. I ASSUMED that this was due to the film not having tension when finished, and also hot licking the paper to wind around it/not having rubber bands.
FAST FORWARD TO LAST WEEK
I have a roll of Provia 100 120 in my Pentax 6x7 MLU. The roll was in my camera for a week, but it was still (TAUGHT) in the camera from a wedding a few days before. I had five frames left when I finished the roll. When I finished, I instantly opened the back (after advancing a few times to make sure the roll was done), and the roll was unwinding AGAIN!!! It looked EXACTLY like the 400h roll, and this Provia was brand new! When you put your fingers on the roll, there is a ton of slack on the sides, and you can push it in and out. This roll I am going to develop though.
ALL THIS BEING SAID, WTF IS HAPPENING? THIS SH*T IS EXPENSIVE, AND I USE IT FOR WORK.
Has anyone else experienced this?! Are there ways to fix it?!
PLEASE HELP ME!! <3