u/HOXIT4444

Hi😁

This is a follow up post on my previous problem.

Old problem is fixed but new problem arrived.

First i create the fill on the first two inside circles which is ok.

Then i make a rule area priority "no infill".

After that i make the biggest area a zone and fill it.

Everything looks nice until I press B which refreshes the infill and then the first small circle fill disappear.

Is it a way how to make the rural area if I was being applied to the internal circle?

Thanks.

Hi.

I have been banging my head against the table for last hour.

I need to fill each of the rings while the space between them stays empty.

This is all on Cu layer.

Can someone please with more knowledge tell me how to do it?

Thanks😁

Update: There was a 0.5mm clearance from the board edge which didn't allow me to fill it properly. Problem is fixed. Thanks