u/Human_Passenger_7668

Consistently having issues with CC1 prints. At first I was using PETG, and sometimes my PETG print wouldn’t print at all (start print, come back, nothing was on plate) and then if I did nothing but just start the print again it would work. I then started getting issues where the print would start but at some point (layer 4/5 maybe?) it would stop extruding. I thought it might be a filament humidity issue so I switched over to some dried PETG-CF and that too ran into the same issue of not extruding around layer 4/5. Manual extrusion afterwards always works though.