u/Initial_Cake_3079

Currently have the controller and two switches with multiple access points. I bought a router to have a failover system (starlink as backup) however I cannot get this router to adopt to my system.

What I've done so far:

I connected to my desktop, set up login and password. Updated to latest firmware available.

On the controller settings I have changes default LAN to 192.168.1.1 from 192.168.0.1.

After initial adopt fail it asks for username and password to the router (one that I setup) which I put in but it still fails to adopt.

The error I keep getting is the device failed because it is not responding to adopt commands.

The only thing I can think of is the router's ip address ends in "0.1" instead of "1.1"? Im not sure how to fix this? Appreciate any advice! Thanks in advance!

https://preview.redd.it/gzemhdzyepuh1.png?width=742&format=png&auto=webp&s=8872e79dff76c6b033d138cbdd3be6ad0ebdd628

This is probably a dumb question but I'm new to the omada system. If I wanted to have a failover system do I need to buy an omada router?

Currently only using starlink but at some point (hopefully soon) will get fiber and plan to have starlink as backup.

Current system has an omada controller with SG2428LP switch and 4 access points (3 EAP770 and 1 EAP772)

Thanks in advance for your help!

Hey guys,

I recently switched to the omada system and everything else has been working fine but I can't seem to get my printer on the network. I've tired both wireless and wired methods. I've tired turning off the 5ghz network. It seems like the network won't assign the printer an IP address. Any suggestions?

I figured connecting it through ethernet should have been straightforward since it looks like these older printers struggle with newer wifi tech but am baffled as to why ethernet still won't work.

Thanks in advance for your help!