▲ 0 r/Makera
X Axis Limit Triggered
Hello has anyone come across the following issue: During the homing sequence, the machine hits the x limit switch but does not backoff and it triggers the alarm for homing sequence failure.
The carvera controller is running on the most up to date software and firmware and there are no loose terminals on the X-MAX connector. I have tried resetting the machine by powering off and unplugging the power and usb cable and manually moving the spindle to backoff the switch. However, the failure continues once powered on and rehomed. Additionally, my project is within the boundaries of the machining area so no limits should be triggered.
Please see below of picture of the limit switch after it has tried to home. Appreciate the help.
u/Julizette — 7 days ago