u/KennedySunday

Just over a year ago I had an extension and a new floor laid over both section.

The new part is block and beam, the old part is 12mm ply over suspended beams which are accessible under house through a hatch. We put an UFH overlay then 12mm screed over the whole thing followed by Amtico.

I noticed a few weeks back that I can see the crossbeam that sits under the joists through the floor. Queue slightly panic.

I spoke to my builder who said we likely need to upgrade joists and struts. Should I trust him to get on with it or get a structural engineer to review?

What is the safest course of action here?

I’m totally gutted. It was a lot of effort to work out the best UFH option and that part worked well.

For many many years I ran an RBR40 (upstairs front) daisy chained using wireless backhaul to an RBS40 (downstairs back) and that through to an RBW30 to extend WiFi from our garage for the rare occasions I need WiFi outside. Recently I got a home battery that hated this system after many years of no problems.

I looked around and all the newer WiFi 7 routers like the Orbi 770 and Unifi Express 7 that seemed to be much better until wireless backhaul and walls got in the way. Darn those houses with walls. And they come at a cost.

I made a rash decision to buy a second hand RBR50 and RBS50 and it’s transformed everything.

I don’t need the third satellite anymore, the home battery is happy connecting and it’s rock solid.

My internet speeds from the satellite are really good. 450Mbps down and over 600Mbps up(!) from my 1Gbps service where max using Ethernet is around 980Mbps.

Super happy with this setup. Just because it’s old doesn’t mean it’s not good thanks to the Voxel firmware.

Today I admitted defeat after updating the app and everything breaking again. Proceed with caution if considering purchasing.

I’m formally rejecting this product that is not fit for use and doesn’t work as advertised.

I’ve had countless issues and wasted hours of time trying to resolve. Majority of issues are down to poor software and hardware implementation/integration but ultimately I’ll focus on today and the fact the unit simply refuses to charge from the mains/grid, so I can’t use it to offset low and peak energy costs as intended. I’ve turned it off and on 4 times. Deleted everything and reset up once. And that’s today alone.

You can clearly see in the video below that:

1. The unit is connected to my real-time energy meter and is showing the live feed on my house
2. The unit is connected to the internet as I can view and save settings
3. The unit clearly isn’t charging at the rate set…in fact a longer video shows that it starts discharging.
4. I’m not using anything other than the dumb “charge now” option.

 

I cannot get the unit to consistently charge and discharge to any sort of schedule. I’ve tried since I received the device to get it to work and it’s only worked for 1 day out of 7. The rest have been issues, disconnects and things not working. 

 https://youtube.com/shorts/bG7FLTx4t-M?si=3i1J83wANHcKzwb4

Nothing about this product is good apart from the case and probably the batteries. The UI is poor. The functionality is hard to understand. The device doesn’t do what it says or what you ask it to do.