K2plus printing with 0.2mm nozzle, Experiance sharing
Dear all
I'm struggeling since about 3~4 month now with printing on the K2Plus with an 0.2mm Nozzle and it keep getting wors.
In the beginning, on my first attemtps wo print with a 0.2mm Nozzle, it went right into the bed and destroid it and the nozzle.
After many Emails between Support and Online reserching, I did eventually tought it was related to the bad Bed beeing curved like 1,3mm all over. So I did change the bed to an IDE-3D bed. Id did help inissially, but I keep having problems:
for Once the Z-Offset is constantly terrible. The bed mesh is acually pretys good with 0.13~0.17mm overall flatness, but still I have to correct every print about +0.07mm ~+0.095mm... Even if I go in the profile higher, it keep getting troubbles... I don't get it what I do wrong.
Anyone does consistent prints fnished with the 0.2mm nozzle? or should I just exchange this junk for an Bambulab H2D and stop waysting my time with it???