So my extruder kept getting clogged was using pla cf. was cleaning it out and BOOom the wiring came loose and now I’m getting a new extruder
What should I get, or should I take it somewhere and get the wiring soldered back on.
Yo yo yo!!
Ok so I have this problem where my prints are not coming out ok?
To be honest I don’t know this is just a phenomena on my printer.
Or am I thinking about it too much?
Check the vids and pics.
Any mods to help out, using PLA-basic from Elegoo
So I have been using Elegoo slicer did the calibration tests and all that good juice, but what if I use orca slicer will that make my prints better because it’s has bedder mods. Or is this more of like, the grass is greener on the other side type of slicer.
Using pla basic any mods recommend ok elegoo slicer
Wanting to do helmets, weapons, cosplay and shit like that.
Ok let’s say,
1)That I located the best z offset by standing in front of my 3d printer screen and adjusting thought there (for me .045 down)
2)Then I went to the elegoo slicer on my laptop and then hit save on the printer setting.
Boom done. And everything is on factory settings.
With the new update and I hit print!
3)Do I have to hit auto bed leaving for every print from my laptop. For evey print?