Exam Topic Discussion & Practice Question - 3.0 IP Connectivity
This week's discussion topic is 3.0 IP Connectivity.
If you have any any issues or points of confusion on this topic, this is your thread.
To kickstart the discussion, here's a question from 3.1 Interpret the components of routing table:
>Looking at this routing table entry:
>S 10.0.0.0/8 [1/0] via 192.168.1.1, GigabitEthernet0/0
>Which of the following are true? (Choose two)
>A. The route was learned via a dynamic routing protocol
>B. The route was manually configured by an administrator
>C. 192.168.1.1 is the next-hop IP address
>D. GigabitEthernet0/0 is the destination network
>E. The administrative distance is 0
You're invited to share and compare answers in the comments.
I'll post the >!concealed!< solution below, but please try to answer by yourself first!
u/MTT_Dylan — 11 days ago
Exam Topic Discussion & Practice Question - 2.0 Network Access
This week's discussion topic is 2.0 Network Access.
If you have any any issues or points of confusion on this topic, this is your thread.
To kickstart the discussion, here's a question related to 2.6 Describe Cisco Wireless Architectures and AP modes:
>Which of the following are non-overlapping channels in the 2.4 GHz Wi-Fi band? (Choose the best answer)
>A. 1, 2, 3
>B. 1, 6, 11
>C. 2, 7, 12
>D. 1, 5, 9
You're invited to share and compare answers in the comments.
I'll post the solution in a couple of days!
u/MTT_Dylan — 17 days ago
Exam Topic Discussion & Sample Question - 1.0 Network Fundamentals
This week's discussion topic is 1.0 Network Fundamentals.
If you have any any issues or points of confusion on this topic, this is your thread.
To kickstart the discussion, here's a sample exam question:
>For what two purposes does the Ethernet protocol use physical addresses?
>A. to uniquely identify devices at Layer 2
>B. to allow communication with devices on a different network
>C. to differentiate a Layer 2 frame from a Layer 3 packet
>D. to establish a priority system to determine which device gets to transmit first
>E. to allow communication between different devices on the same network
>F. to allow detection of a remote device when its physical address is unknown
You're invited to share and compare answers in the comments.
I'll post the solution in a couple of days!
u/MTT_Dylan — 23 days ago