New to Resin Printing. Delamination or something else? Any suggestions would be appreciated.
Hey folks, I just started resin printing, and I’m loving it so far, things are a bit messy but I am lucky enough to have paid attention to the great advice here and have the proper ventilation and space to prep, post process and print with minimal mess.
I am printing on the Elegoo Saturn 3 Ultra, with the Anycubic Water Wash Resin 2.0.
While printing this enclosure, I ran into the defect seen in the picture attached. It seems like delamination to me, but I am unsure why this is occurring, and how to troubleshoot it. Any advice would be appreciated.
Print Settings:
Normal Layer:
- Exposure time: 2.5s
- Lift distance: 3mm, 4mm
- Wait before cure: 1s
- Retract Distance: 5.45mm, 1.5mm
- Wait before lift: 0s
- Lift Speed: 90mm/min, 320mm/min
- Wait after lift: 0s
- Retract Speed: 320mm/min, 90mm/min