u/MrPain__

Hi All

Im having an odd issue and hoping someone might have a solution. Ive onboarded esxi host syslog via logscale, however the data connector is idle and we are not seeing any logs.

We are using custom ports which have been specified in the configuration, and opened on the firewall. The configuration also has cisco syslog which is coming through fine to the same collector.

Ive tried creating separate configurations, rebuilt the data connector multiple times, tried using the generic hec connector, used wireshark to confirm the logs are being sent from the esxi host to the log collector on the correct port, disabled any firewalls between hosts and confirmed outbound connectivity over 443 to the CS console.

As far as I can see, the network connectivity is fine, given then other log sources are all active.

Any thoughts / suggestions / help would be appreciated as it driving me nuts!

Apologies if this has been covered many times! I did try and have a search!

We have just got a hermanns with a table and a combined heat / uvb bulb and lamp. After setting it up, we realised that the basking spot was getting way too hot, above 36c. We don't have any way to raise / lower the lamp and from my understanding you cant use a dimmer thermostat with these types of bulbs, plus you don't want the sun going on/ off all day!

Any suggestions? I was thinking of using another spare lamp i have from my gecko to do just uvb and use a ceramic heat bulb for the basking spot?

Any help would be appreciated as there is s fair amount of conflicting info on thsse particular set ups!

Thanks