I have the stock ender 5 print head with a cr touch and the sprite direct drive conversion kit and was wondering if anyone has tried and succeeded in printing tpu on it bc of the distance between the extruder and the hot end.
I just upgraded to an skr mini e3 v3 and I’m using the firmware from bigtreetech. I’m wondering if anyone has seen this issue, I’ve tried changing my z steps from 800 to 400 with no avail and changing my proble offset but maybe I did it wrong
I just upgraded my Ender five to a new board and installed a CR touch onto it to replace my old BL touch. I’m having issues with the CR touch which is shown in the video that it will stow without touching the plate and then whatever leveling process that was happening cancels out. I attached videos of it happening and videos of all of my settings. I also tried changing the Z steps to 400 and I’m still having the same issue. (i’m not able to attach more than one video so I’m attaching the YouTube video guide that I followed, which has the firmware on it. I’m using the default values provided in this firmware which are specific to the ender 5)
I’m wondering, what is the best way to install the new firmware for my BL touch onto my under five. I have the hex code file from reality which is their official firmware. And I also have my Arduino. In the past, I attempted to use Prog isp to install the firmware, but it only wiped my board and never uploaded the firmware. I then used arduino IDE and it worked for a while but then my motherboard bricked. One of my friends was taking apart their old ender 3 and I asked if I could have his motherboard and he gave it to me. It’s the same motherboard that I had previously, but I’m wondering which is the best way to upload the new firmware or if I should go a different route that I’ve already gone.