u/Ok-Caregiver-1689

Update to yesterdays post:
Fucking hell guys, that bread tricked worked. Got an m12 bolt, as inner diameter was 12mm of the bearing. Popped out in less than 3 min. This wicked! Thank you all.
For the folks that don’t know..basically if you have a blind bearing, you put bread in the center, smash it with a pin that fits tightly, and repeat. In the end the bread will act as some sort of hydraulic fluid that presses the bearing out 🤣.

Guys. Help.
Struggling real hard to remove a stuck bearing that is deep inside an electric motor.
I’ve got an inner bearing puller, but the issue, I can’t grab it with a wrench to tighten (to expand) as it’s inside a motor stator.
See picture…please help.