Hey my Riso I picked up about a week ago started suddenly doing this weird double impression/over inking. It only happens on the first ten prints of a run then it clears up sometimes the bottom is also coated but not always.
Is something wrong with the main roller?
Found this printer this morning it was gathering dust in the back of an old print shop.
Owner said it had a sensor problem? Idk I picked it up for so cheap it was basically free.
Update turned it on and it’s reading check settings, I’m very green to this but will consult YouTube
I recently made the switch and traded my 87 Harley for a bike I could ride more and wrench less. I got a really good deal with the bike only having 17k on the Od
After some mild early wrenching (blew my primary case gasket off) I decided to take the ol thang on a surf trip to the coast. About 600km with some logging roads.