FYI genPHA works great with allPHA profile in Prusa Slicer
Just posting for general knowledge for those with a CoreOne in case it hasn't been mentioned yet here. I recently bought a CoreOne+ (kit version), and noticed that Prusa Slicer has a build in profile for ColorFabb allPHA. I tested the profile, as is, with no modifications with genPHA and it works fantastically well. Shown below is a benchy in blue genPHA filament. Incidentally, this was also printed on one of the recently recommended BuildTak Pro plates, which also works great (no brim, glue or tape involved!).
Still no PHA profile listed for the Prusa Mini+, but I've been rollin with my own custom profile so far for my Mini, so I'm good there. But it's encouraging to see official PHA support pop up in Prusa Slicer. Perhaps they will port it to their other printers as well.
