Hallo, ich habe heute meine BMCU in Betrieb genommen. Jetzt hat der leider Probleme mit dem Wechseln. Er meckert das kein Filament vom AMS kommt.
Habe ich beim Flashen vielleicht was falsch gemacht?
FW 10.5 von Pavel.
Was kann das sein? P1S.
Viele Grüße ☀️
Hi, I’m currently setting up and reconfiguring my devices. Is there a "master config" where I only need to swap the role?
Here is what I have:
1x Heltec V2,
3x Heltec V3,
1x Heltec V4,
and 1x Raspberry Pi HAT.
The V4 is currently attached to a Pi5, acting as a central base station. One V2 is at the campsite connected to Wi-Fi. One V3 is serving as a repeater in the office, and two other V3s are used as mobile pagers; plus, I have a T-Deck Plus.
What is the best way to create a master config where I basically only have to change the name and the role? (868 MHz). Many thanks.
Hallo, meine BMCU mit der Pawel Firmware 10.5
AMS-A 80cm nimmt nur auf Slot 2 das Filament an.
Alle anderen hört man nur das der Motor brummt. Aber das Filament wird nicht eingezogen.
Was kann das sein?
Viele Grüße ☀️
Hello, I have a Gamma 601 and a Gamma 602. The 602 often runs at 95–100%, while the 601 runs at only 40%. I have set up both units identically. At the front, each unit features a Noctua NF-A4x20 5V PWM—a quiet, premium, 4-pin, 5V fan. At the rear, the 602 has a Noctua NF-A4x20 (a quiet, premium, 3-pin, 5V fan), whereas the 601 has the old PowerMining fan originally from the 602. Why are their fan speeds so different?