u/SliceComprehensive41

This took a while to make coz i was working on it approximately 30 mins a day. Finally finished

This was really really difficult. Removing the stock cape was the easiest part. I made maybe a total of 5 versions of the cape. The easiest to install was the version 2 which only had wires on the side but ehh i really wanted a good cape to accompany the amazing articulation of the figure. Then made a few versions that was wired on every peak which didn’t wanna stay on and i broke the cape clasps, coz the pegs are really tiny and aren’t designed to hold that many wires. This version is wired the same amount as the original cape, but i made sure the wires are anchored down. They loop around the pegs and i drilled a tiny hole at the back for the middle spine wire to feed into.

In the end, i think it paid off. Im satisfied for now…. Until i feel the itch to design a new neck to make the installation process easier