Replacement pulleys for table saw
Hey everyone. I inherited my fathers 113 saw that he and I used growing up. The problem I'm having is that the pulleys are coming loose during use (almost in danger of flying off!) In searching around it looks like the best solution would be to replace the stock aluminum pulleys with cast iron ones.
The shaft that the engine side pulley goes on (I'm sure I'm not using any of the correct terminology, sorry about that) seems to be marred up a bit, should that be replaced to?
Any help would be greatly appreciated. Also, if the answer is to get the cast iron pulleys (or any other parts) if you have a recommendation of where to source them that would be helpful. I looked around but didn't find anything that seemed to match up with what I might need.
Thanks in advance!