u/krakerag

I'm just putting it together now and I think it's basically got two rods that I've had to seperate from the pedal plate that are factory created back to front, so the pedal tray literally can't be installed. I've attached a pic of the two rods - I've detached them from the tray.

If I could remove the retaining bolt off one end and turn it around, it would be fine, or if I could slide the end off the sliding part and turn it around, it would be fine, but I can't do either as they're not designed to be changed like that.

I've attached a picture of them as they have come off the pedal plate.

Any thoughts?

As as well as this I can't even register the product on the website - it says 'registered successfully' and then refuses to show that i've registered any products in the account. Very odd.

I'll use the support link given throughout this sub in a few other posts also.

Hey all.

When shopping for rigs I find specific dimensions really hard to get, which is odd because most people are trying to fit a new rig into a very specific space, so getting accurate dimensions is important.

For the wheelbase, how high is the wheelbase plate off the ground? There is a height specified in the dimensions for the rig (93.5cm) but it doesn't really specify if this is the top of the chair, top of the wheelbase, etc. I am going to try and use this with my monitor attached to my desk and am curious if it will fit.

Also if possible, can someone measure for me the distance between the wheelbase and the front of the pedal tray, at it's maximum extension, as I will be limited in space under the desk. I feel like it will fit considering the listed dimension for length is 119cm, but I'd like to be sure.

Thanks all

Just purchased F1 DD - brake extension rods incorrect from factory.