u/ncoa

Anyone have a low profile plate mount? Looking for something that tucks in the tail more

I seem to be dripping oil from the bolt circled in red. This is right behind the shifter. Trying to figure out what that part is. Bike is a 2026, brand new only been on the street so far. Less than 600 miles.

I bought these axle sliders for my 450RL. The brake side slider fits fine but the sprocket side does not fit at all. The lip or bevel on the axle does not allow it to fully seat in the slider. Has anyone else had this issue? Trying to get in contact with warp 9 to see what’s up.

I’m having issues with shifting from 1st to neutral. It’s extremely hard to shift at a dead stop and usually skips neutral completely. I think the issue is with the clutch cable and the clutch lever I’m using. Got a knock off RSC off Amazon. Has anyone changed the actual cable out ? I’d like to get rid of the 90 degree angles on the stock cable.

My buddy, green bike, has almost the same setup and is using the stock cable, but his is longer. I bought this bike used so not 100% what all was done with it.