I was using the framing tool, and it crops into my photo... Does this bother anyone else? I end up having to use the expand tool with white bars then crop, which is hard to keep centered...
I have some 35-48v 500w bldc motors (e-skateboard motors) that I want to use for my robotics projects. They are much higher power than the small gimbal motors I typically use with Simple FOC drivers, so I'm wondering what's the typical setup for these high power motors.
Power supply: better to use a big lipo battery or a wall power supply? From what I've seen, batteries can provide more current but are kind of dangerous?
Controller: I want to use an FOC drive to precisely control position. the motor has an encoder built-in. I was looking into the ST G431 driver, but I'm not sure if it can handle so much power.
I'm quite new in BLDC control and high power electronics, any advice or info would be really helpful!