u/tooting_pop_front

Looking for any recommendations for a 100amp esc (120amp burst) needs to be 12s comparable. Anything with FrSky comparable telemetry would be stellar.

Having recently started using the vacuum resin infusion method I am hooked.

I am looking for ideas on how to produce a very thin layup. The finished part will be 100g carbon, 1mm balsa core, 50g glass.

First thought is lay up the carbon, pre bond the 50g glass to the balsa then bond in the balsa afterwards.

From my experience so far the problem would be getting the peelply and flow mesh off the carbon without it demoulding or being damaged.

I know this sounds complicated but I hate wet layups and keeping the weight down is critical (rc aircraft fuselage)

Any thoughts gratefully received