The $25 A1 update
Ive gotten it very very close and much better than it was before. I did the manual bed tramming and that’s helped quite a bit. But Im noticing it seems to be consistently skipping particular parts of the print which confuses me. I figured its because one of the points was too far away from the bed. I spent a ton of time trying different distances and always doing a full bed level calibration afterwards. I kept getting this result shown in the pictures. It seems to be skipping the same parts consistently. Some lines are clean and some not at all. Here is the link to my previous post that details all of the trouble shooting Ive tried. Thank you all! https://www.reddit.com/r/BambuLabA1/s/AqnUhw33RV
Edit: yes I have washed the build plate. Thinking of just ordering the A1 mini combo, should I?