OpenGrid quad corner connector with wall mount?
Hey all. New to and recently committed to going into the OpenGrid universe and printing off my first boards to give me a 1m x 1m area initially.
I have been looking high and low for a solution and wondered if anyone here knows of one but I am trying to figure out if there is something like this but for opengrid: https://thangs.com/designer/MultiBuild/3d-model/6.25%20mm%20-%20Quad%20Offset%20Snaps%20%28DS%20Part%20A%29-993369
So I want to be able to connect 4 opengrid boards together at their corners and then use that to mount to the wall so I am minimising how many holes I am putting into the wall, whilst also hopefully allowing me to still use those squares if I needed to as well.
I have no experience in design atm but maybe I'll need to go down this road.
Thanks all