r/BalisongClones

Honestly for first impressions. No tune, just carbon honey this is amazing.

Tuned for u/siyaheven

37 bucks for an arguably better flipping experience than a real kraken (subjective obviously)

Changed Thomas balisong Refault bowie blade to an ATD memento blade, feels really good so far.

So far a grail 😂

aint the best clip il post more when I get back from vacation

https://www.instagram.com/p/DaVf9uRMcii/?igsh=MXZqamp5NDE4d3dwdg==

I had to retune it so I did but even now it has a little bit of a tap when it's not moving at all inside the handle and I'm talking only about safe handle. There is no blade rub but I really don't like tap in my knives and when they don't have a perfect tune.

I wanted to check out some orcas but i realised the model i was looking for was sold out but other models were in stock but i have no info on how the diff models flip, like if you guys know, whats the balance of it, weight, is it neutral, handle or blade bias. I need help for this specific model!!

I have 3 spacers for you
• one with similar dimensions to the original spacer
( I shall refer to this as the "sd")
• full length heavy
( "flh" )
• full length light
( "fll" )

sd:
lightest of the bunch @ 1.22 grams, imo this is the least enjoyable spacer, it lacks ass weight even with all three screws - and can be a pain to flip

flh:
@ 1.95 grams, this is the heaviest out of the three, i usually use two screws to hold it in place, even then it can feel 'too' handle bias

fll:
@ 1.81 grams, this is similar to the flh, two screws feels best, this one is the best out of the three, however, would do better if some weight was shaved off. this can be achieved by adjusted the percentage infill

original:
@ 5.01 grams, this is the heaviest, it is awful.

Here are the files to print! I hope you enjoy them
STL files

This one was a lot more difficult

Handles repolished, blade repolished, custom spacers printed, repaired, and reinforced with superglue, double stacked polished pb washers, tuned.

This took a while haha, all done for u/playornanow

Cerakote alu, blade bushings and pivot area polished and tuned by me, hardware upgraded. If you've ever flipped a knife and thought it was "flowy", this knife is the epitome of that. It is a little slippery on the faces, but the jimping is the best I've ever felt

new acc old one got banned :(