Im in the UK on the octopus intelligent tariff WITH Ohme charger, its supposed to decide when is best to charge when rates are lowest in the day.
How do I stop these constant notifications on my iPhone? I imagine its when the charger is switching on and off deciding when best to charge?
I dont want to silence notifications from the app completely as I do want to be notifed in the eveng something goes wrong etc
Hi all, does anyone have any home product suggestions or recommendations on how to fix scuffed alloys?
I’ve got a fair few similar to the photos across all four wheels.
This is a lease vehicle and I’d like to attempt to get them all fixed before handing it back later this year.
Or is this beyond home solutions and I should just get them fixed professionally? (UK resident)
Cheers.
Look what came in the post today.
Seems to affect Tavascans produced between 09/08/24 - 14/02/26.
3 hours repair needed if it’s affected.
Hi all. I have a Cupra Tavascan, 2025 plate with 10k miles on it. Yesterday while driving home from work I was stopped at a junction when suddenly the dash showed a load of yellow errors - tyre pressure indicator not working, ACC not working, front sensor not working, rear sensor not working, washer fluid empty, drive motor failure. The car wouldn't pull away from the junction, so I put it into neutral and put my hazards on. Toggled it back to Drive and I was able to pull away and park up round the corner. I turned the car off fully (got out, waited a few minutes then got back in) and on turning the car back on there were no errors showing. I drove home with no issues.
On checking it over I did notice that a system software update had been installed during my drive. Has anyone had a similar experience, do you think this needs to go to a dealer or should I just see if it happens again? The car is through work so any repairs are covered but I've also heard people are having to wait months for appointments with Cupra dealers at the moment.
ETA: I should mention the car had a washer fluid empty/low warning earlier in the day and when I turned the car on to drive home, so that warning was already showing.
Hi everyone,
Looking for some troubleshooting advice on my UK Cupra Tavascan. My HVAC / ventilation has completely stopped working (zero air movement unless I open the windows), and I’ve now also got a yellow drivetrain warning light on the dash.
Crucially, the car is NOT in limp mode and drives completely fine otherwise—it's just the annoying yellow light, no cabin air, and the thermal management after locking the car going into overdrive.
Troubleshooting steps already taken:
Current Symptoms:
Next Steps & Dealer Availability: The 2 Local dealers can’t see the car until Wednesday October 21st 2026.
Before I try disconnecting the 12V battery to force a full power cycle, has anyone had these combination of errors or found a workaround? Thanks!
Is this possible?
I have just taken delivery of a Tavascan but for the next few weeks I still have a Born.
When I try to add the Tavascan I get a message saying the VIN is correct but not ready to link to the system.
Email back and forth with app customer care has resulted in them saying I need to take it to a dealer as the slowly blinking red light on the SOS button means there is a hardware fault.
Anyone else had such issues? Do I really need to go to dealer? They’re not exactly local.