r/Cura

Hey all, just wanted to ask you about a problem I encountered. I tried running a temperature tower test. I set up the temp changes in the post processing scripts and made one for each section. The print was going good for the first layer but after that one was down the temperature switched to my default pla temp. I am going through the settings now and I am not sure where I went wrong.

the apply to setting is set to subsequent layers so it should apply from the set layer till the next change specified in the next script. I tried going back and setting a range in the change layer but there is no way to add multiple layers in that box so I am at a bit of a loss.

Any insight would be greatly appreciated!