r/DistillateVapeMods

Hi there, hope someone can help me. I’ve got some disty and cdt and I was hoping to make some vapes and needed some advice. The dispensary I get vapes from currently use the standard 510s, I’m happy to experiment or use them as I have a few empty ones to test on.

My main issue is the mix percentages, I’m conscious of not getting it too thick by putting minimal % of cdt in, but equally don’t want overbearing it with too high a % of cdts with the disty.

I’ve purchased a magnetic metal plate spinner off amazon. I was going to be conservative and try 3/4% on the first batch? Not sure what you guys thinks? If I’m not happy with that batch can I mix it up again and add more cdts?

I wasn’t planning on getting anything else to add to the mix but reading this forum I’ve seen there’s a few things you guys add to yours. Is the disty and cdts enough? Any recommended pods or alternatives to the 510s, or the magnetic hot plate spinner, any advice on using that or trusty ones? I am on a budget so would appreciate the recommendations to bear that in mind..

Thanks in advance to anyone who can help with any advice or best practices, sorry if it’s already been done to death!

Hello everyone, I am having a hard time finding a vaporesso NRG or the CCELL coils near me currently, and all of the reccomendations I have been abe to find wandering in the depths of this awesome thread, have been for tanks and for coils that are either discontinued, or are very hard to find especially locally. I have an RPM, I have a nord, and a few others that will work fine if I had to use them but I am looking for the new shiny way to smoke disty, so please all reccomendations are helpful!!!!

I fill carts but I'm wanting to make a batch with a pod type system to make it a little easier. I was looking at the ikrusher keylo pro because they're postless, but I'd really prefer something I can obtain easier and on more than just a couple sites in the future.

I run more carts than flower these days, so I have a fat jar or two of a full spectrum THCA distillate from a place that used to be, to dip my toe into some savings. This stuff is straight glass. It is a translucent amorphous solid.

I can fill a cart, but find it hard to believe anyone can actually run this stuff in 510 hardware without a preheat torch or turning it into hotdog water.

Rather than let the cart decarb, should I pop the whole jar on the hotplate/in the oven for a bit and take advantage of the D9 viscosity shift?