BOttom part of the S1 effector
I needed to get a replacement effector for my S1 after some serious issues with a giant blob of plastic breaking the effector apart from the inside.
I was never able to process a payment through the official FLSUN store when trying to buy the effector there, so i had to try aliexpress, Original FLSUN S1 PRO Effector Full Assembled Hotend Kit 3D Printer Component Print Head - AliExpress 7.
When the part (finally) arrived, i noticed it not having the bottom part, only a 3D-printed airflow thingy (see pic below). I am guessing there has been a design change, but that still does not explain the lack of the lower part of the effector (with sensor/cam?).
Can I still use this, or do I have to make any changes on the printer as it would not have the electronics that were present on the old effector?
And no, i cannot just mount the old "bottom part" as that was damaged during the previous stated blobbing and also during the resolving of this. I could try soldering it where some of the contacts were damaged, but one of the connectionpads is missing (and I also am struggling to find schematic of where the wires on the connector should go)
