by NTS 3D Printing
My modular 3D printed LED grid system is finally finished
The setup is run by GLEDOPTO WLED controller running latest 16.0.1 version of WLED!
#3dprinting #wled #led
The lamp has 12 strips of 18 LEDs in series, each strip in a circular pattern around an old filament spool. The diffusor and other structural parts are 3D printed. It’s all held together by a 8mm threaded rod. The LEDs are controlled by a Gledopto controller. The 30W PSU and the controller sit in the bottom of the lamp.
I'm hoping someone has run into this issue. I have a GLEDOPTO Elite 4 Channel controller running 2 seperat led strips. I also have a
APIELE 22MM Mushroom Head Push Button Switch Momentary Push Button for manual control. Everything works fine until the controller sits.for a period of time. Then nothing works and I need to unplug the controller to reset, then the button works. Also have the controller integrated with Home assistant if that matters. Any thoughts?
I did notice when things are not working the relay noted in the attached pic is green. After reset it's grey.