r/SoloSatoshi

It’s impossible to record how quiet something is lol. I turned off the HVAC and fans and tried not to breathe and you can hear my dog tip toeing in the living room 😂 heat cycling the ptm a few times before we really push it. PR so far is 15.3 th/s. What do you guess she’ll do now?

Arctic LF iii pro 240 with a 120 noctua at 100% on the back side. Pretty sure most of the db comes from the back. I built this thing to survive the hot garage but it’s so pretty and quiet I may just keep it on my desk. It’s whisper quiet in here lol I expected quiet but wow.

New
Diagnostics page — per-miner, per-operating-point breakdown of pool vs reported hashrate, capture %, effective hashrate, implied vs reported error, and per-setting share reconciliation
stratum reconstruction diagnostics — set_difficulty count, pool difficulty, submits/plotted/dropped, extranonce1 status, recent targets and diffs
Network block timer — time since the last block found network-wide, in the Windows top bar and both fleet cards, counting up live
Fleet pace made per-miner honest — each miner judged against its own work and best, so staggered restarts no longer skew the fleet number
Session-best clearing now restart-corroborated — a firmware best-drop only clears the share list if uptime also reset; glitches keep the list
Session-best events logged to Crash/Restart Reports — reviewable Session Cleared / Best Kept cards instead of watching the live log
Newer firmware support — captures extranonce1 from the mining.subscribe reply, not just the older extranonce_str line; covers old and new firmware
Enlarged green top-bar stats (Shares / HR / Block) matching the card and button green, filling the bar without growing it
Uniform miner-bar button heights and trimmed bar padding on Windows
Linux / Umbrel variant brought current, including a Node port of the N miner diagnostics with a byte-verified self-test

Previous
Remove a miner without losing its history — offline it and re-add the same IP later to reconnect to its data
🧹 Purge Miner — completely wipe a miner from every store (Windows global button + per-miner on mobile)
Per-miner all-time clear — wipe a single miner’s all-time Best Diffs or HR Scores, syncing both ways
Dynamic Governor — auto-adjusts frequency/voltage/fan to hold temperature, VR-temp, and current bands, with dwell/settle timers, 24hr scheduling, and restart-after-adjust
Governor amps band — cap current draw to protect the input connector, not just temperature
VR fan control — set the VR fan’s mode, manual speed, and PID target independently of the ASIC fan
Correct target-temp & min-fan reading across firmwares — no default snap-back; Min-Fan shows only where supported
Multi-sensor temperatures — per-ASIC and per-VR labeling, with per-ASIC hashrate/error stats
Per-panel Y-axis zoom on the hashrate chart to reveal a steady miner’s real variation
Hashrate-only controls (HR / View / Y) appear on the hashrate chart only
Difficulty parsing handles K/M/G/T suffixes
Crash/Restart reports fire once per outage instead of repeating
Notification deck — toasts stack into a tidy, tappable deck
App mode browser launch (no throttling)
Port cleanup on startup
Time range dropdown
Efficiency stat on Windows and mobile
Crash/Restart Reports system
Chart history persists across session resets
Stall detection on mobile
Scripts drag-and-drop reordering with bidirectional sync
Battery saver refresh options
Mobile App Settings restructure
Updated launcher behavior
Tracks target difficulty set by the pool
Tracks session best up to 500 difficulties
Tracks all-time best up to 500 difficulties
AxeOS Scoreboard integration (supports up to 500 entries)
Automatic deduplication of scoreboard entries
Tracks average share time
Live difficulty chart with scroll and zoom
Live hashrate chart
Live temperature chart for all ASICs and VR
Trace back temps 41 hours to see if a miner overheated when it crashed
Full miner settings — frequency, voltage, fan
Full pool settings — primary and fallback stratum
Nameable miners
Custom miner colors
Auto-restart after 5+ minutes with no shares
Max 3 auto-restarts per hour with warning
Stall detection — stats zero out after 30 seconds with no hashing
Block found alert with audio
Total watts display
Total hashrate display
Live power cost calculator ($/day)
Live block finding odds calculator
Scripts engine — automate miner settings based on conditions
Scripts support temperature, hashrate, frequency, time of day, and more
Scripts sync bidirectionally between Windows and iOS
iOS companion app
Customizable theme colors on iOS
Improved mobile viewing
Per-miner temps-only view on iOS
Auto-restart toggle on iOS
In-app notifications on iOS
Block found banner and audio alert on iOS & Windows
Remote access via Tailscale
Launch in preferred browser
Total color control with themes
Stalled miner notification when miner is stuck in power fault, etc.
Accepted share chart dots — green 0–1M, yellow 1M–100M, red 100M+

Requires Windows/Umbrel/Linux for server, then works on iOS/Android via browser app. Instructions in the readme.

Windows
https://github.com/iL3GEND88/Bitaxe-Difficulty-Tracker-/releases

Mac/linux/umbrel
https://github.com/iL3GEND88/Bitaxe-Difficulty-Tracker-Umbrel-Linux/releases/tag/V7.0

Hi, since im upgrading my setup to Avalon Q, i am selling my stuff here, i have 2 zyber 8s 6,4Ths per unit, 5 avalon nano 3s 6.5 Ths, and two bitaxe 1.4 ths per unit overclocked, and a lucky miner 1.2ths overclocked, i still have all boxes
- bitaxe 100$ canadian per unit
- avalon nano 3s : 250$ canadian per unit ( i have 5 )
- zyber 8s (6.4Ths) : 250$ canadian per unit i have two units
Or i can do 1000$ for everything, shipping here in canada is 30$ and to USA its 40$

Finna see what this thing can really do. I think I got it close to max on the first 3 mods but it’s not much fun to be in the same room with 😂 if my maths line up it should run a bit harder with solid temp control and be dead silent. Waiting on couple more parts to arrive. This should be good (or I’m ordering a new one) don’t try this at home, you really can just do things.

From components to a working Bitaxe Gamma 601. 🔧⚡

Built, powered on, and ready to mine Bitcoin. ₿

#Bitaxe #Gamma601 #BitcoinMining #SoloMining #HomeMining

She’s got more in her. 😈

Hi everyone,

I want to share my experience with the 'Bitaxe Supra Hex 701' while trying to push it to a higher hashrate.

My setting was Freq/Vol 550/1200 (exp hashrate 4.21 TH/s),however the miner started showing "Power fault detected"

I then switched back to the default parameters Freq/Vol 490/1166. It can go 3.75 TH/s stably.

After checking the hardware, I suspected the issue might be related to VRM. I added small heatsinks directly on the inductors, and after that everthing goes well.

My guess is that during high-frequency operation, the inductors were overheating or experiencing increased power loss, causing the power protection circuit to trigger.

Has anyone else experienced similar issues with Bitaxe Supra Hex 701 when overclocking?

Huge thank you to everyone who supported the launch. The Bitaxe Gamma Hex is officially sold out and we're blown away by the response from this community.

If yours has already arrived, post it and tag us. We'd love to see them in the wild.

Missed out? The official restock is happening this week!

https://www.solosatoshi.com/product/bitaxe-gamma-hex/

A new generation of desktop Bitcoin miners built on Bitmain's BM1373 chip is hitting the market, and the marketing deserves scrutiny. Watch for spec sheets that pair the overclocked hashrate with the low-power efficiency number. Those come from two different modes you can't run at the same time. One newer unit advertises 3.2 TH/s and ~11 J/TH in the same headline, but at 3.2 TH/s it actually runs 14.2 J/TH. Its honest stock operating point is 2.1 TH/s at 22W.

These chips are also carrying a heavy first-to-market premium.

So we ran the actual cost of ownership at both devices' stock chip frequencies, using the US median electricity rate of $0.17/kWh (chart attached):

Thor X1 (1× BM1373): 2.1 TH/s, 22W, 10.6 J/TH, $269
2× Bitaxe Gamma (BM1370): 2.4 TH/s, 36W, 15 J/TH, $144

Five-year net cost: $272 for the two Gammas vs $310 for the BM1373 unit. The newer chip's efficiency edge is real, but at residential rates it saves about $18/yr, meaning it takes ~7 years to repay the $125 price premium. Longer than these devices will realistically run, and the Gammas give you more hashrate and open-source firmware.

Neither earns a dime at residential rates. Every home miner is a slow-drip cost, not an income stream. Buy one for the hobby, the education, or the lottery ticket. Just do it with the real numbers, not the headline ones.

Your Gamma Hex ships ready to mine right out of the box. No firmware update is required to get started.

Please note that the Gamma Hex firmware is not yet available on the Bitaxe webflasher. We ask that you refrain from flashing your Gamma Hex with any other Bitaxe firmware currently listed on the flasher, as those builds are not compatible and will render the device unusable or bricked. Keeping the firmware your device shipped with ensures reliable operation.

Firmware is added to the webflasher once it has been merged into the main branch of ESP-Miner, so the flasher typically lags behind new releases. The Gamma Hex firmware remains fully open source, and the code is available for review here:

Source code: https://github.com/benjamin-wilson/ESP-Miner/tree/gamma-hex

Should you need the factory image or .bin file, it can be downloaded here:

Factory image: https://drive.google.com/file/d/18wZEfCngM5uGVexwzGJdBHozR45CM-TL/view?usp=sharing

The factory image can be flashed through the device UI, the recovery screen, or using the following flashing tool:

Flashing tool: https://esptool.spacehuhn.com/

When important updates are released, they are typically announced through GitHub or the official Bitaxe and OSMU channels, and we recommend monitoring those sources.

If you require additional assistance, please contact us at solosatoshi.com/support.

Meet the New & improved Bitaxe DUO in a preproduction sneak peak.

The Bitaxe DUO will fetaure 2 x BM1373 chips from the Antminer s23 and an upgraded LCD display screen.

The open-source bitcoin mining revolution continues!

More information to come soon!

We pushed the Bitaxe Gamma Hex to >13 TH/s and it didn't break a sweat! 🥶

Home mining just got a huge upgrade! The Bitaxe Gamma Hex is now in-stock and shipping today from our Texas warehouse!

• No pre-sales.
• No paying to wait in line.

Be a part of the open-source home mining revolution and grab your Bitaxe Gamma Hex while supplies last!

https://www.solosatoshi.com/product/bitaxe-hex/

Much appreciation to ArielBravy for providing this short video.

The Bitaxe Gamma Hex has officially launched, and we're celebrating by giving one away to our community!

This is the most powerful Bitaxe yet! One lucky winner takes it home for FREE.

👉 Enter here: https://x.com/SoloSatoshi/status/2085403139641905511

How to enter:
✅ Follow us
❤️ Like the official giveaway post on X
🔁 Share it
💬 Tag a friend who should be mining

Had to mod, it’s what I do. See comments