r/dmtguide

So i did the outiside evaporation and i woke up this morning and it looks like this please someone help me and tell me whats wrong maybe has been 3-4hrs already

So I’m attempting to dry this batch I made, I poured the solvent off the top, sat it in front of a fan, went to check it a few hours later and theres still liquid (I can’t tell if its solvent or water) and the dmt has absorbed into that liquid.

I plan on heptane washing, to clean up the color, but what can I do to make it dry? Blow dryer? Scrap this batch? I just wanna know is there something I can do to save it?

Has this happened to anybody else? Out of the 100x I’ve done this, This is my first time encountering this issue. I’m thinking maybe I pulled some of the water when I was siphoning off the solvent and it all froze together

my “nn-dmt” cart js arrived in the mail. never had a dmt pen of my own and my online vendor who has gotten me good shipments of other psychedelics offered a listing of nn-dmt w a ceramic coil, i js wanna know if it should be moving sround this much or if the oil should look thicker

Super proud of myself. First tried dmt 3 years ago, been reading on extraction for 2, and I finally decided to dive in. It was super fun.

I used 250g MHRB powdered to do a AB tek for extraction, I asked for whole chips but got sent powdered by mistake. I've also done several STB from the same bark and got around 2% yields so I know the bark is quality.

I started by boiling 250g MHRB in distilled water with citric acid added until a pH around 2 was achieved then proceeded to boil the bark for half an hour then strained out the bark with bubble bags that range from 250 micron down to 25 micron. I then squeezed as much juice out as I could then added the bark back to the pot and repeated the same steps 2 more times for a total of 3x 30 minute boils.

I then ran the tea through the bubble bags twice to make sure I removed as many particulates as I could then reduced the tea down to 700ml total. From there I put it in an erlenmeyer flask and added sodium hydroxide until I acheived a pH of around 12 the added 30g of salt and finally heptane.

After putting it in a warm water bath I then mixed it thoroughly for 5 minutes then let everything separate. Then did my pulls, I have done 3 pulls on it so far and all of the pulls have yielded next to nothing, like not even 0.2g in total and from 250g I was expecting around 5g. I've done plenty of AB and STB before with multiple different species of acacia and mimosa holistis. I did everything as I normally would except for the straining as I usually have whole chips for AB.

My question is where could all the dmt be? I saved the bark I boiled it's just in the freezer but after boiling 3 times in an acidic solution I would assume it should be completely depleted. Any ideas where it could be?

So Got This Off from 100g powdered bark, For the first pull, Is it A good Yield? OR mediocre ¿ Appreciate all input thanks All 🙏

This is my third batch, a mini one if you will. The last 2 didn’t turn out, but this time…

Turned it into a vape already and it’s 🔥!

So proud of myself lol

Woke up to this in the Jar !.. This Is Good Right¿

Just bought this and it's my first time

I've never attempted anything like this before. Based on other photos I've seen, it doesn't look bad. This is the first pull from 100g of MHRB. I have a second pull currently in the freezer. Any tips/advice/direction?

NOT TO SHABBY for a rookie, With unnecessary Equipment I dare say !Always room to improve tho !!