u/-DonMichel

Hey y’all, I just bought myself a 3D printer and I’ve been dabbling a bit with shapr3D to learn how to draw models.

On my first design I was wondering if the fact that these are two different pieces stuck together would create a weak point in the print or does not matter.

Would it be better to make it in a single piece by just extruding everything from a cylinder ?

I bought this pressure washer 3 years ago, didn’t have any problems yet but I’ve used it for the first time of the year today and I barely have no pressure.

Starts fine, I have pressure but nothing compare to what it was before.

Water pressure from house is the same it ever was.

Tried all the tips and none of them a clogged.

Gas is full, throttle to the max.

Purged the air from the pump.

Inlet screen is clean.

What do you guys think could be the problem?

I changed my house hose for a longer one, could a longer hose reduce the pressure? I still feel like the pressure is the same it was before changing it when I use the hose without the pressure washer.

Worked on this today. Framed the niche to have full tiles all around.

I’m installing this back splash and I’m not sure on the orientation of the top part of the window. Personally I prefer going the same orientation as the sides but someone on the job told me same orientation as the wall, what would you do?