u/224us

Need some help with a DS Lite F2 fuse issue. I attached a picture of the area I’m working on. I’m not getting any continuity from the F2 fuse and wanted a second opinion before I go any further.

Pretty sure I caused this myself. I replaced the bottom screen and didn’t add backing/electrical tape to the back of the screen.

Does everything in the picture look correct or am I missing something obvious? Also, if the F2 fuse is dead, is it possible to bridge/jumper over the fuse or would I need to completely remove the fuse first before doing a bridge?

I’ve been reading mixed info online so I’d rather ask people that actually work on these boards. Any troubleshooting tips or things I should test next would help a ton.

Anybody know of a website where you can mix and match Game Boy housing shells?

Picture for attention! Picked her up for 10 bucks!!

Hey everyone,
I’m in the middle of trading for a Nintendo DSi and wanted to get some opinions before it arrives

The current owner says the only issue is that the left and right triggers are iffy and bulged

I don’t have it in hand yet, but my first thought is it could just be a reshell issue—like the buttons not lining up right, springs out of place, or maybe the rubber contacts aren’t seated properly.

For those of you who’ve dealt with this before:

Does this sound like a simple reshell/alignment fix?
Or is it more likely worn-out tact switches that need replacing?

Could it just be dirt/grime inside the triggers?

Any quick tests I should run as soon as I get it?

I’m comfortable opening it up if needed, just trying to figure
out what I might be getting into.

Appreciate any advice 🙏