Cone 5/6 glaze 2 part schedule
Hi, I recently upgraded my kiln to an older Duncan 46 x 60cm kiln with a ipco 3300 controller. I did my first bisque and glaze stoneware firings with it and it under fired by a few cones. I watched the controller readings several times throughout the firings, and it was reading as it should. I know kilns fire differently, even when firing the same schedule. So before I look into new elements or pyrometer, I wanted to see if I can find a schedule that works first. Unfortunately my controller only allows for 2 sections in the firings, so I’m looking for 2 part schedules. The bisque I used 80C/hr to 600C, then 200C/hr to 1000C. And glaze 120C/hr to 600C, then 220C/hr to 1222C. So if anyone has a schedule that works for them I would appreciate it so much if you could share it, as the schedules I can find online have 4-6 sections. If 2 section firings aren’t very reliable then I’ll look at a new controller. Thanks