Default Purging Temp on the K1 Max
How do I change the default purging temp of 220 degrees on the Creality K1 Max. I am using a filament that runs between 190 & 200 and every time I start to try & print anything the head moves over to the poop shute & the filament runs through the line into the hot end & it starts purging @ 220 then moves out from the shute and pauses while it tries to drop down to the required temp of 195 but all the filament bleeds out of the hot end then it moves over to the left side tries to print a few vertical lines then stops & resets back to 220 & then drops back down to 195 before moving over to print the job but by then all the filament has bled out of the hot end again and whatever I am trying to print is ruined because the first few seconds of the print have no filament available. Thanks in advance Regards Peter D