u/Admirable-Bread3227 — reddlx

Is this something to do with bed adhesion or z offset maybe?

I'm very new to 3d printing and my cousins asked me for a keychain for their sons birthday, since its multicolor i want to print as many as i can in 1 bed but i keep having issues with them, at first i tried 36 in one but i had to cancel it cause they were too close and messed the object detection and couldn't cancel single ones if they failed, i keep getting some of them fail and idk if its because they had poor bed adhesion or maybe the z offset is too low and knocks them down. I have a Kobra X (using the default high quality profile)

I have been looking to increase the brim on the supports but i haven't been able to, only the width of the supports itself.

They failed around 30% and it being the one with bigger area makes me believe its the z offset since the smaller supports its well stuck to the bed, i didn't have much issue with other prints and i need to do another 25 soon so i would like to know if its a me problem or maybe the print itself its just difficult

https://preview.redd.it/j21zrqzj6w1h1.png?width=1200&format=png&auto=webp&s=de4ff74a6cadf38cecd6ed2f7e4d3d5630255c5c

reddit.com

u/Admirable-Bread3227 — 4 days ago

▲ 1 r/AnycubicKobraX

4th Channel gives clogging alert all the time

idk if it was a firmware update or what but the 4th channel starts printing and just gives clogging alerts, i click resume and sometimes keeps printing for a bit before another one or just instantly gives a clogging alert while purging before restart

reddit.com

u/Admirable-Bread3227 — 13 days ago

▲ 27 r/AnycubicKobraX

The Kobra X is my first 3d printer, i have been done some single colors prints (only thing i did multicolor was a test hueforge) and since i knew i was getting a printer i wanted a mew figure, took me a bit to find a model i liked (cant remember exactly where from but shouldn't be too hard to find) and then add the knitted texture, used https://bumpmesh.com and Blender for it, i think it came out pretty good and saved me of modeling it on blender from 0 cause the displace modifier was not giving a good result (could be me not doing it properly tbh), but i think it would have been easier to do it from 0 that try to adjust it to an existing model that was not intended for it, that's where the page i linked before came, i did modify the eyes in blender to remove the texture cause i couldn't do it on the page.

Anyways some results:

-	Model	Support	Flushed	Tower	Total
Slicer	91.96g	39.54g	57.69g	19.23g	208.42g
Print	96g	41g	53g	20g	210g

Pretty much the same, total time was little over 16h

219 color changes, 2h 38m slicer time

I might upload it to makeronline tomorrow, but i have never done it and im lazy

u/Admirable-Bread3227 — 28 days ago